Harold Bawlzangya Racing

Posts tagged “how to remove blind bearing

Blind bearing removal – no puller required

You don’t need too much to get the blind bearings out of the cases.  What you are trying to do is to force a material back behind the bearing so it applies pressure to the bearing to push it out.

I was fortunate enough to have some leftover parts that I could use to get the bearings out.  You could use anything as long as it fits tightly within the inner race of the bearing.  You don’t want the material you are using to escape between the inner race and whatever you are using to force the material back behind the bearing.

BlindBearingRemovalTools

(click picture to enlarge)

I use plumbers putty:

PlumberPutty

(click picture to enlarge)

And some heavy duty packing paper.  Newspaper can work OK, but when you wet it down, it tends to disintegrate much easier than this brown packing paper.

BlindBearingRemoval-Paper (10)

(click picture to enlarge)

The transmission bearing:  For this one I use plumbers putty, it makes quick work of removing the bearing. Fill the bearing up:

TransmissionBlindBearing (1)

(click picture to enlarge)

Then hammer it in:

TransmissionBlindBearing (2)

(click picture to enlarge)

Keep repeating that process of adding more putty and hammering it in until the bearing starts to lift out:

TransmissionBlindBearing (3)

(click picture to enlarge)

TransmissionBlindBearing (8)

(click picture to enlarge)

TransmissionBlindBearing (9)

(click picture to enlarge)

TransmissionBlindBearing (12)

(click picture to enlarge)

TransmissionBlindBearing (13)

(click picture to enlarge)

TransmissionBlindBearing (15)

(click picture to enlarge)

TransmissionBlindBearing (16)

(click picture to enlarge)

TransmissionBlindBearing (17)

(click picture to enlarge)

Water pump bearing:  I did a little experiment here, I used a combination of the brown paper(dry) and plumbers putty.  It is a little difficult to see, but I’ve packed some of the dry brown paper down into the bearing.  This is to try to keep the plumbers putty from getting forced up through the openings in the bearings.

BlindBearingRemoval-Paper-PlumberPutty (4)

(click picture to enlarge)

Add some putty:

BlindBearingRemoval-Paper-PlumberPutty (5)

(click picture to enlarge)

Hammer it in and keep repeating:

BlindBearingRemoval-Paper-PlumberPutty (6)

(click picture to enlarge)

BlindBearingRemoval-Paper-PlumberPutty (7)

(click picture to enlarge)

BlindBearingRemoval-Paper-PlumberPutty (8)

(click picture to enlarge)

The leftover mess:

BlindBearingRemoval-Paper-PlumberPutty (9)

(click picture to enlarge)

 BlindBearingRemoval-Paper-PlumberPutty (10)

(click picture to enlarge)

The KIPS governor bearing:  I’m using just the wet brown packing paper on this.  Same approach as the other bearings.

BlindBearingRemoval-Paper (1)

(click picture to enlarge)

BlindBearingRemoval-Paper (2)

(click picture to enlarge)

BlindBearingRemoval-Paper (4)

(click picture to enlarge)

BlindBearingRemoval-Paper (6)

(click picture to enlarge)

BlindBearingRemoval-Paper (9)

(click picture to enlarge)